Gear > Weapons & Armor
Share your Weapons designs for next Rag with the new weapons rule passed.
Syr Olaf:
now with the new rule that passed this Rag.....
.4.1.5 - Two- and & a half-inch rule: No part of a weapon's striking surface, whether the tip, the edge, the face or any other part, may pass easily more than 0.5" through a 2.5" diameter hole when tested in the direction of the strike.
4.1.6 - Two-inch rule: No non-striking component of a weapon, such as a crossguard, a non-striking tip, or a pommel, may pass easily more than 0.5" through a 2" diameter hole when tested perpendicular to the striking surface or shaft of the weapon.
4.1.11.2 - All swung weapons must conform to the following:
4.1.11.2.1 - Blue weapons must weigh at least 12 ounces.
4.1.11.2.2 - Red weapons must weigh at least 24 ounces
4.1.11.2.3 - Swung weapons must balance above the unpadded handle section.
maybe some vet foam techs can share with Dag community some designs that will pass this next Rag.
Arrakis:
Here's a good one:
Roll a sheet of 1/4" 2# Volara around a piece of .524 kitespar (with biscuit on) until it's 2" across. Add a layer of bluefoam to the tip; add a layer of marine foam to the tip. Wrap one more full wrap of the volara around your stick.
Add weight, handle, pommel, and cover.
Win.
K"urn:
Are those the actual rule re-writes? Does that mean there are no more length requirements?
K-
Meager:
Length requirements are still there, just not posted. What's different is that there's no more minimum dimensions.
K"urn:
So the length minimums are still in place but the width and thickness minimums are not.
Good. I was worried for a second there.
K-
Navigation
[0] Message Index
[#] Next page